How to Fit WBTR Aerowiper Wiper Blades

Hook fitting 

1. Remove the V3 cover from the wiper blade by peeling it away from the fitting and discard. 
2. Open up the lid on the adaptor. We recommend using a small screwdriver to gently pop it open. 
3. Fit the hook wiper arm onto the blade by slotting it into the adaptor before closing the lid. You should feel a firm click if this has been done correctly. 
4. Insert the V1 housing (cover) onto the adaptor to complete the look of the blade. Don’t forget to remove the protective strip. 

Pinch tab 

1. First, remove the V3 cover from the fitting. To do this, simply peel it off the attachment and then discard. 
2. Locate the end of the wiper arm into the slot on the blade. 
3. Close and pinch this into place using the tab. 
4. Don’t forget to remove the green protective strip at the end before use. 

Push button (19mm) 

1. Firstly, remove the V3 cover by peeling it back and unclipping it from the attachment. This can then be discarded. 
2. Locate the end of the wiper arm onto the tabs.  
3. Pinch the tabs in with your fingers while sliding the arm up and over onto the blade. This should click firmly into place. 
4. Remove the green protective strip at the end before use. 

Push button (22mm) 

1. First, remove the V3 cover from the fitting. To do this, simply peel it away from the blade and put that to one side. 
2. In the bag provided, locate the V2 cover. This will be the smallest one. Attach this onto the fitment as shown in the video. 
3. Fit the wiper onto the wiper arm by pinching the tabs while sliding the wiper arm into place. 
4. To finish, remove the green protective strip on the wiper blade edge. 

Side pin 

1. Line up the pin vertically with the side of the adaptor and slot this into place. You should hear a clicking noise. 
2. Lower the wiper arm back down to a horizontal position over the wiper blade. 
3. Remove the green protective strip to finish.